Strainrite Netting Strainer Board – 1900mm (75"), Wedge Clamp

Strain the Whole Sheet at Once, Not Wire by Wire

Straining netting one horizontal at a time is how a fence ends up with a wavy top line and uneven tension down the sheet. A strainer board grips the full height of the mesh and pulls it as one piece, so every wire comes up together and the fence goes on square. The Strainrite 1900mm Netting Strainer Board is the press-formed steel board for that job, in the wedge-clamp design.

At 1900mm (75") it suits taller netting — sheets where a 1530mm board can't reach the top wire.

This listing is for a single board. A complete straining set-up uses two boards and three boundary strainers, sold separately.

Features

Full-Height Grip — Strains the whole sheet of netting at once instead of wire by wire, for square mesh and even tension from the top wire to the bottom.

Wedge Clamp Design — Grips the netting without damaging or stripping the wire coating.

1900mm (75") Height — Sized for taller netting that a 1530mm board can't span.

Press-Formed Steel — Formed steel construction built for repeated straining loads.

Galvanised Finish — Corrosion resistance for a tool that lives on the truck and in the weather.

Specifications

Brand: Strainrite
Part number: FNB00034
Type: Netting fence strainer board
Overall height: 1900mm (75")
Clamp type: Wedge clamp
Supplied as: Single board only (a complete system uses 2 boards + 3 boundary strainers)
Construction: Press-formed steel, galvanised finish
Compatible with: Most mesh, hinged-joint and ring-joint netting
Range: Netting Fence Strainer Boards & Sets

Grip the whole sheet, pull it square — taller netting that goes up straight and stays that way.